Accuracy and Estimation · Cambridge syllabus 1.9, 1.14 · Lesson 1 of 1
Accuracy
Significant figures count from the first non-zero digit; decimal places count from the decimal point. Keep guard digits in intermediate work and round the final answer as requested. Estimate with convenient values to detect a misplaced decimal.
By the end, you can
- Use decimal places and significant figures correctly.
- Round only at appropriate stages of a calculation.
- Give answers to the degree of accuracy requested.
- Estimate calculations using convenient approximations.
- Use estimates to check calculator answers.
- Judge whether a result is sensible.
Rounding
Accuracy runs through every topic, and the two ideas are rounding and the bounds it implies.
Decimal places count digits after the point; significant figures count from the first non-zero digit. In 0.00456 the first significant figure is the 4, so to 2 significant figures it is 0.0046.
Round only at the end of a calculation. Rounding an intermediate value and feeding it into the next step accumulates error, and in a two-stage question that is often enough to lose the final mark. Carry the full value in the calculator memory instead.
Give an answer to a sensible accuracy for what it describes. Three significant figures is the usual default when a question does not say, angles in degrees are given to 1 decimal place, and money is given to two decimal places.
Three more conventions from the syllabus are worth knowing. An answer that is exact to four or five significant figures, such as 1250 or 3.375, is left as it is rather than rounded. When a question asks you to show that a value is correct to a given accuracy, give your answer to at least one more figure than asked for, so 2.4 to 1 decimal place is shown as 2.43. And a single answer should not mix fractions and decimals: write 5/6 rather than 2.5/3.
Worth remembering
- Decimal places count after the point; significant figures from the first non-zero digit.
- Round once, at the end. Three significant figures is the usual default; angles to 1 decimal place.
- Leave answers that are exact to 4 or 5 significant figures unrounded.
Estimation
A rounded measurement stands for an interval, and the bounds are its ends: half a unit of the last recorded place either side. A length of 4.8 m to 1 decimal place lies in 4.75 ≤ length < 4.85.
The upper bound is not included, since it would round up, but it is still the value used in calculations.
Writing down the bounds of one rounded value is Core. Choosing which bounds to combine in a calculation is Extended, and takes thought. The greatest sum uses both upper bounds. The greatest difference uses the upper bound of the first and the lower of the second. The greatest quotient uses the largest numerator and the smallest denominator — making the answer bigger means making the bottom smaller, which is the one that catches people.
Estimation is the other half of the topic: round every number to 1 significant figure and work out the simplified calculation, as a check on an exact answer or as an answer in itself when the question says "estimate".
Worth remembering
- Bounds are half a unit of the last place either side; the upper one is excluded.
- Calculations (Extended): greatest difference is upper minus lower; greatest quotient is upper ÷ lower.
Worked example
0.004786 to 3 significant figures is 0.00479; 198 × 5.1 is approximately 200 × 5 = 1000.
Practice
Warm-up · not marked
Check your understanding
Answer in your own words, then compare with the worked answer. Nothing here is saved or scored.
Worked answer
38.75 and 39 respectively.
Check your method, units and explanation against it.
Marked practice
Set 1 of 5 · easiest first · Checked as you go, with the worked answer. Sign in or create a free account to save your progress.