Light · Cambridge syllabus 3.2 · Lesson 2 of 5
Refraction
Includes Supplement objectivesLight changes speed at a boundary between transparent media. Entering a higher refractive index usually bends it towards the normal. For light entering a material from air, n = sin i ÷ sin r. At normal incidence the speed changes without a change in direction.
By the end, you can
- Explain changes in direction and speed.
- Use ray diagrams for glass blocks and prisms.
- Describe an experiment, using optics pins or a ray box, to show refraction by transparent blocks of different shapes.
- Define refractive index, n, as the ratio of the speeds of light in two different regions. [Supplement]
- Recall and use n = sin i ÷ sin r. [Supplement]
- Describe the dispersion of white light by a glass prism.
- Know the seven colours of the visible spectrum in order of frequency and in order of wavelength.
- Recall that visible light of a single frequency is described as monochromatic. [Supplement]
Refraction through transparent materials
Light travels more slowly in glass, water or perspex than in air, and that change of speed at the boundary bends the ray. As with reflection, angles are measured from the normal: the angle of incidence is between the incoming ray and the normal, and the angle of refraction is between the refracted ray and the normal. Entering glass from air, light slows and bends towards the normal; leaving it, back into air, it speeds up and bends away. A ray that arrives along the normal slows down but does not change direction.
A rectangular glass block shows this neatly. The ray bends towards the normal on entry, travels straight through, and bends away again on leaving. Because the two surfaces are parallel, the ray emerges travelling in its original direction but shifted sideways. A triangular prism is different: its faces are not parallel, so both bends turn the ray the same way, towards the thick base of the prism, and it leaves in a new direction.
You can show this with a ray box or with optics pins. Place a rectangular block on a sheet of paper and draw round it. Shine a narrow ray at one face at an angle and mark the incoming and outgoing rays with two crosses each, or push two pins into the paper along the incoming ray and line up two more pins with their images seen through the block. Remove the block, join the marks, including the path inside the block, then draw the normals and measure the angles. Repeat with a semicircular block, aiming the ray at the centre of its flat face: it enters the curved side along a radius, which is a normal, so it bends only at the flat face.
Everyday effects follow. A straw in a glass of water looks bent at the surface. A swimming pool looks shallower than it is, because light from the bottom bends away from the normal as it leaves the water and your brain traces it back in a straight line. A coin hidden behind the rim of an empty cup becomes visible when the cup is filled.
Worth remembering
- Into glass: slower, bends towards the normal. Out into air: faster, bends away.
- A rectangular block shifts a ray sideways; a prism turns it towards its base.
- Trace rays with a ray box or optics pins, then join the marks and measure angles from the normal.
Refractive index
Refractive index, n, is the ratio of the speeds of light in two different regions. For a material, it is the speed of light in a vacuum divided by the speed of light in the material; the speed in air is so close to the vacuum value that the same number serves for light entering from air. It has no units, since it is one speed divided by another, and for a transparent material it is always greater than 1.
Air is about 1.0, water 1.33 and typical glass 1.5. A refractive index of 1.5 means light travels 1.5 times more slowly in the glass than in a vacuum, so at 3.0 × 10⁸ ÷ 1.5 = 2.0 × 10⁸ m/s.
For a ray passing from air into a material, n = sin i ÷ sin r, where i is the angle of incidence in the air and r the angle of refraction in the material. A ray striking glass at 40° to the normal and refracting to 25° gives n = sin 40° ÷ sin 25° = 0.643 ÷ 0.423 = 1.52. The equation also works backwards: light entering glass of n = 1.5 at 30° has sin r = sin 30° ÷ 1.5 = 0.333, so r = 19.5°, found with the inverse sine key.
Two cautions. Both angles are measured from the normal, as always. And the angle in air always goes on top: since the ray bends towards the normal on entering the denser material, the angle in air is the larger one, and n must come out greater than 1. If your answer is less than 1, the angles are the wrong way round.
- n = c ÷ v
- Refractive index is the speed of light in a vacuum divided by the speed in the material.c = 3.0 × 10⁸ m/s in a vacuum, v in the material. n has no units.
- n = sin i ÷ sin r
- Refractive index from the angles, with i the angle in air and r the angle in the material.Both angles measured from the normal.
Worth remembering
- n = speed of light in a vacuum ÷ speed in the material. No units, always > 1.
- n = sin i ÷ sin r, with the angle in air on top.
- Water n ≈ 1.33, glass n ≈ 1.5.
Dispersion
Send a narrow beam of white light into a triangular glass prism and a band of colours comes out of the other side. This spreading of white light into its colours is dispersion. White light is a mixture of colours, and each colour travels at a slightly different speed in glass, so each is refracted by a slightly different amount. Violet is bent the most and red the least, so the colours fan out into a spectrum. Raindrops do the same to sunlight, which is how a rainbow forms.
The visible spectrum is traditionally divided into seven colours: red, orange, yellow, green, blue, indigo and violet. Learn them in that order; a phrase such as Richard Of York Gave Battle In Vain helps. Going from red to violet, the frequency increases and the wavelength decreases, so red light has the lowest frequency and the longest wavelength, and violet the highest frequency and the shortest wavelength. In order of increasing wavelength the list simply runs backwards: violet, indigo, blue, green, yellow, orange, red.
Light of a single frequency is described as monochromatic: it is one pure colour. Light from a laser is very nearly monochromatic, which is why a laser beam passing through a prism changes direction but does not spread into a spectrum. White light is the opposite, a mixture of many frequencies.
Worth remembering
- Dispersion: a prism splits white light into colours because each colour refracts by a different amount.
- Red, orange, yellow, green, blue, indigo, violet: frequency rises and wavelength falls along this order.
- Violet is refracted the most and red the least.
- Monochromatic light has a single frequency.
Worked example
From air to glass with n = 1.5 at i = 30°, sin r = sin 30°/1.5, so r ≈ 19.5°.
Bend a ray at a boundary
Part of the full Physics course. This unit’s free simulation is Make a wave.
Practice
Warm-up · not marked
Check your understanding
Answer in your own words, then compare with the worked answer. Nothing here is saved or scored.
Worked answer
It slows and bends towards the normal because glass has higher refractive index.
Check your method, units and explanation against it.
Marked practice
Set 1 of 5 · easiest first · Checked as you go, with the worked answer. Sign in or create a free account to save your progress.