Types of Data Transmission · Cambridge syllabus 2.1 · Lesson 2 of 2
Simplex, Half-Duplex and Full-Duplex
Simplex allows data in one direction only. Half-duplex allows either direction but not simultaneously. Full-duplex allows both directions at the same time. These describe direction of communication, not whether bits travel serially or in parallel.
By the end, you can
- Understand simplex transmission.
- Understand half-duplex transmission.
- Understand full-duplex transmission.
- Identify suitable examples for each transmission mode.
- Describe the advantages and disadvantages of simplex transmission.
- Describe the advantages and disadvantages of half-duplex transmission.
- Describe the advantages and disadvantages of full-duplex transmission.
- Explain which transmission direction suits a given scenario.
Transmission direction
Direction of transmission is a separate question from whether bits travel serially or in parallel. A link can be serial and full-duplex, or parallel and simplex; the two descriptions do not overlap.
Simplex carries data in one direction only, and the receiving end can never reply on that link. A television broadcast, a radio broadcast and the signal from a sensor to a controller are all simplex.
Half-duplex carries data in both directions but only one at a time. Each end must stop before the other can start. A walkie-talkie is the standard example: you release the button to hear the reply.
Full-duplex carries data in both directions at once, so both ends can send and receive simultaneously. A telephone call is full-duplex, as is a broadband connection, and so is most modern networking.
Half-duplex does not mean half speed. It means half the time, in the sense that the channel is shared by turns rather than split in capacity.
Worth remembering
- Simplex: one direction only, as in a broadcast.
- Half-duplex: both directions, but only one at a time, as on a walkie-talkie.
- Full-duplex: both directions at the same time, as in a phone call.
Advantages and disadvantages
Each direction has advantages and disadvantages, and choosing one for a scenario means weighing them against what the link has to do.
Simplex is the simplest and cheapest: there is only one direction to provide, the whole channel is always used for sending, and the two ends never get in each other’s way. Its disadvantage is that the receiver can never reply. It cannot say that data arrived, ask for data to be sent again after an error, or send anything of its own, so simplex only suits data that genuinely flows one way, such as a broadcast or a sensor sending readings to a computer.
Half-duplex allows replies while still using a single channel, which is cheaper than providing a path in each direction, and whichever end is sending has the whole channel to itself. Its disadvantage is waiting. Only one end can send at a time, so each must wait for the other to finish, which slows two-way communication down, and if both start sending at once the data collides and must be sent again. It suits links where the two ends take turns, such as walkie-talkies.
Full-duplex is the fastest for two-way communication: both ends send whenever they need to, so nobody waits, and an acknowledgement can travel back while data is still being sent. Its disadvantages are cost and complexity, because it needs a path in each direction, such as separate wires, or a channel whose capacity is shared between the two directions. It suits a phone call, a video call or a network connection, where both ends must send at the same time.
In an answer about suitability, link the method to the scenario: a sensor that only ever sends readings needs simplex, because nothing comes back; a phone call needs full-duplex, because people talk and listen at once.
Worth remembering
- Simplex: cheap and simple, but the receiver can never reply or report an error.
- Half-duplex: replies on one channel, but each end must wait its turn.
- Full-duplex: fastest two-way, but needs a path each way, so costs more.
- Choose the direction the scenario’s data actually needs.
Worked example
A broadcast is simplex; a push-to-talk radio is half-duplex; a telephone conversation is full-duplex.
Practice
Warm-up · not marked
Check your understanding
Answer in your own words, then compare with the worked answer. Nothing here is saved or scored.
Worked answer
Half-duplex: both directions are possible, but only one transmits at a time.
Check your method, units and explanation against it.
Marked practice
Set 1 of 5 · easiest first · Checked as you go, with the worked answer. Sign in or create a free account to save your progress.